TT RGB PLUS Software
2.0 - New version of Thermaltake’s TT RGB PLUS patented software, providing more lighting effects and PC monitoring functions.
1.0 - Thermaltake’s patented software to synchronize TT RGB PLUS products with addressable LEDs.
Caution: TT RGB PLUS 2.0 and TT RGB PLUS 1.0 will overwrite one another; users can only install one version of TT RGB PLUS.
TT RGB PLUS 2.0 Software
The new version of Thermaltake’s TT RGB PLUS patented
software, providing more lighting effects and PC monitoring functions.
TT RGB PLUS 2.0 and TT RGB PLUS 1.0 will overwrite one another; users can only install one version of TT RGB PLUS.
Sync with Razer Chroma Lighting
All Thermaltake TT RGB PLUS products are able to connect into the Razer Chroma ecosystem, Razer Synapse 3. Users can experience synchronized gaming and RGB lighting effects on their TT RGB PLUS liquid cooling system and Razer gaming gear!
Thermaltake recommends the following steps to be taken
Pacific series radiators and water blocks
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.
|Fan Dimension||Fan : 120 x 120 x 25 mm
LED Strip : 30cm -12LEDs
|Interface||USB 2.0 connectors (9 Pin)|
|System compatibility||Windows 7 / 8 / 8.1 / 10|
|Fan Started Voltage||9.0 V|
|Rated Current||Fan 0.15 A (one fan) , 0.48 A (one LED strip)|
|Rated Voltage||12 V & 5V|
|Power Input||12V – 9.45 W . 5V – 16.7W (Fan*3 + LED Strip*3)|
|Fan Speed||500 ~ 1500 R.P.M|
|Max. Air Pressure||1.54mm-H2O|
|Max Air Flow||48.34 CFM|
|Bearing Type||Hydraulic Bearing
|Life Expectation||40,000 hrs,25℃|
- File Name
- Release Date
Drivers & Software
- File Name
- Release Date