New Industrial Style with a Better Grip
The Pacific SF Fittings are forged with Industrial Style Helical Knurling Designed Rotators made with high-quality brass and treated with a special surface finishing, creating a new look with fantastic aesthetics and providing a more ergonomic grip while installing.
Make Building Easy With A Little Help
Pacific SF 45 & 90-Degree Adapters provide convenience and aesthetic purpose while creating a build; you can build a more complex water loop while maintaining the same flexibility to modify or disassemble the system.
Swirl and Adjust
The rotator is 2-way, 360-degree revolvable, bringing convenience during installation and disassembly.
Choose What Fits Best
Pacific SF Adaptors come with different angles, including 90-degree, 45-degree, and 45 & 90-degree, providing a wide range of selections to build your liquid cooling system with ease and more dynamics.
Cautions
Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks:
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse, and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup:
- It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while preventing corrosion in the entire cooling system (copper, brass, nickel, aluminum, and steel).
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
- DO NOT let the pump run dry. If no liquid is entering the pump, turn off your power immediately.
- Fill the reservoir to the top to prevent air from entering the pump.
- If necessary, tilt the system slightly from side to side to bleed the air out of the loop.
- Place paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
- Before starting, flush out your system properly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
- Coolant might fade over time.
| P/N | CL-W398-CU00SL-A |
|---|---|
| Dimensions | 28.1 x 22 x 41 (H) (mm) |
| Weight | 86 g |
| Material | Cu |
| Note | Male to Female 45 & 90 Degree |
| Screw Thread | G 1/4 |
